|
Post by emmings on Feb 1, 2022 13:32:52 GMT
More downsizing. I've got a Firebottle phono pre-amp up for sale with a Sean Jacobs (Custom Hi-fi) DC2 power supply. There's a thread on AOS ( theartofsound.net/forum/showthread.php?26892-FIREBOTTLE-Phono-Preamp) about the phono amp. The DC2 was built to the specs for the phono amp: Regulated High Tension supply. Surge protected dc heaters. Passive RIAA equalisation. Frequency response: ------------------------------ wide --------------------------------- Supply voltage: 12 – 15 volts DC, 1.7A DC input: 2.5mm DC socket, centre pin positive. Input impedance: 47 Kohm, 80 pF. Gain: 44 dB @ 1KHz. Output impedance: 600 ohms. Not been used for a while but it was fired up today and all works fine - sounds good too. I no longer use vinyl which is why this setup is for sale. Back in 2013 the DC2 was £230 and I think the Firebottle was £230 as well. I'm asking for £250 delivered.
|
|
Bigman80
Grandmaster
AA Founding Member & Bigbottle Audio Creator
Posts: 16,144
|
Post by Bigman80 on Feb 1, 2022 14:07:06 GMT
Ridiculous bargain. Absolutely ridiculous.
Good phonostage this, heard one a few times and for the money, it's absolutely spot on.
Wish I knew someone who was looking for one.
GLWS
|
|
|
Post by emmings on Feb 1, 2022 15:27:56 GMT
Just want it to go to a good home
|
|
|
Post by emmings on Feb 10, 2022 19:20:28 GMT
Just want to say thanks to Alan (Firebottle) for his input and help over on the WAM regarding this phono stage - appreciated
|
|